Hello Irresistible Blooms

Hello stampers,

     Today's card was inspired by a sketch challenge from Hand Stamped Sentiments. Yesterday I shared a short video on my FB page about the below set, dies & papers that will be coming on March 1st.

     I started this card with a layer of Basic White Cardstock then took a piece the Hello, Irresistible DSP & cut it down so the 2 sides were the same with the middle a tad larger but leaving a border around each piece. Next, I decided to do some embossing so I used Flirty Flamingo, Daffodil Delight & Granny Apple Green Cardstocks stamping the roses & leaves from the Irresistible Blooms Bundle with Versamark, the white EP from the Basic Emboss Powders & Heat Tool, then die-cut each one using the matching dies. For the sentiment, I used Flirty Flamingo Cardstock & again embossed one of the sentiments from the set then fussy cut the banner end with Paper Snips. I also die-cut a circle from Basic White Cardstock using Layering Circle Dies. I added the DSP layer to a layer of Daffodil Delight Cardstock, then to a Flirty Flamingo Cardstock base. I played around with the assortment before I attached everything with glue, then attached the circle of flowers to the card with Stampin' Dimensionals.

     On March 1st, Stampin' Up! will release some Online Exclusives. These exclusive items will be released throughout the year & will not appear in any catalog. The card above uses a few of these exclusives (dies not pictured). 

Paper Measurements-

• Flirty Flamingo Cardstock:
  • Base – 4 1/4 x 5 1/2
  • Scrap- 2 3/4 x 2 3/4
  • Strip- 1 x 2 1/4
• Daffodil Delight Cardstock:
  • Layer – 4 1/8 x 5 3/8
  • Scrap- 2 1/4 x 2/14
• Basic White Cardstock:
  • Layer – 3 3/4 x 5 1/4
  • Circle- 3 x 3
• Granny Apple Green Cardstock:
  • Strip – 1 1/2 x 4 1/4
• Hello, Irrisistible DSP:
  • Layer – 3 7/8 x 5

~Thanks for stopping by!
All supplies are Stampin' Up! unless otherwise noted.